Its quite simple to expand your ADRadioNet wireless network if you understand the basic configuration techniques. If you decide on your upstream and downstream communication channels, you can easily do this all by yourself as below.
As an example, assume you want to expand your network with 3 more nodes - with 2 end points and 1 router. Adding the original Centerpoint, router and endpoint, you can create a new wireless network as below.
You see 3 end point nodes in the above example, in which EP3 is communicating on channel 3 with the Center Point on channel 0 via Router (R2) on channel 3 and then Router (R1) on channel 2. It is assumed in this example that the upstream rate chosen is 100kbps for EP3, 100kbps for R2, 50kbps for R1, and 38.4kbps for CP. The table below shows the upstream, downstream and channel selected for each of the device in this example network with their respective routing paths.
This FAQ was generated from the following discussion: How do I expand my network beyond evaluation demo