Original Question: EVAL-ADUCRF101 add sensor by cbabin
Hi,
As suggested by @harishkumarkatam I transfer my question here.
I'm using the EVAL-ADUCRF101 sensor kit and would like to know if it's possible to change the bunch wsn boards in order to connect them to another ADI sensor by UART for example and then send both sensors' data to the center point? I have hex files flashed on the bunch wsn boards, is it enough to change these?
Thanks
Verified Answer: RE: EVAL-ADUCRF101 add sensor by harishkumarkatam
Hi,
Answer to your question is posted in the below link, check that and revert back on the same link.
https://ez.analog.com/message/273717?commentID=273717&et=watches.email.thread#comment-273717
Thanks & Regards
Harish kumar k