How to configure the sensor on Bunch WSN?

Original Question: How to configure the sensor on Bunch WSN? by warrensuoqi

Hi Sir!

I have bought EV_ADRN_WSN_1Z. There are two Multi-Sensor Node Boards. One of them is factory-seted to a Triple Axis Accelerometer and anothe to a Humidity&Temperature Sensor. The "ANODE CENTER POINT" can only show limited sensor data as follow figure:

But there are many other sensors on the board. I want to know how to configure them.

Thank you!

Verified Answer: RE: How to configure the sensor on Bunch WSN? by harishkumarkatam

Hi warrensuoqi,

I observe that you are using very old version of the ADRadioNet software on the EV-ADRN-WSN-1Z (Bunch) boards. Please download and install the latest version (ADRadioNet Software ADuCRF101 free, with new PC Tool Rev 2.0.1) of ADRadioNet software from the below location.

http://www.analog.com/en/design-center/evaluation-hardware-and-software/evaluation-boards-kits/Eval-wsn.html#eb-overview

After installation refer to all “ADRN01-All-in-One-GettingStartedGuide-v2.0.1.pdf” in the Docs folder for the information on how to flash the nodes and setup the demo with different on board sensors.

You can also run AD6LoWPAN protocol on EV-ADRN-WSN-1Z boards, from the above link the package can be downloaded (AD6LoWPAN Software – ADuCRF101 free (Rev 1.0))

Hope this helps

Thanks & regards

Harish kumar k

Partner Forums

Partner Libraries

How to configure the sensor on Bunch WSN?

I observe that you are using very old version of the ADRadioNet software on the EV-ADRN-WSN-1Z (Bunch) boards. Please download and install the latest version (ADRadioNet Software ADuCRF101 free, with new PC Tool Rev 2.0.1) of ADRadioNet software from the below location.

You can also run AD6LoWPAN protocol on EV-ADRN-WSN-1Z boards, from the above link the package can be downloaded (AD6LoWPAN Software – ADuCRF101 free (Rev 1.0))