I have bought EV_ADRN_WSN_1Z. There are two Multi-Sensor Node Boards. One of them is factory-seted to a Triple Axis Accelerometer and anothe to a Humidity&Temperature Sensor. The "ANODE CENTER POINT" can only show limited sensor data as follow figure:
But there are many other sensors on the board. I want to know how to configure them.
After installation refer to all “ADRN01-All-in-One-GettingStartedGuide-v2.0.1.pdf” in the Docs folder for the information on how to flash the nodes and setup the demo with different on board sensors.
Hope this helps
Thanks & regards
Harish kumar k