Post Go back to editing

WSN Bunch Node sometimes cannot register

I am using a WSN Bunch node and center point, both loaded with the latest firmware. When watching the packet window in the center point application, nodes occasionally will send one or two registration packets upon powering up, but then stop transmitting without ever sending any data. Other times they will register properly and begin reporting sensor readings. I was wondering if anybody else has experienced this problem and if there are any known workarounds.

Parents
  • Hi Harish,

    Performing the mass reset did the trick; the hardware is now running the V2.0 protocol reliably. There must have been some configuration settings from the old firmware stilled stored somewhere in the modules that was causing problems.

    Thanks so much for your help!

    Tristan

Reply
  • Hi Harish,

    Performing the mass reset did the trick; the hardware is now running the V2.0 protocol reliably. There must have been some configuration settings from the old firmware stilled stored somewhere in the modules that was causing problems.

    Thanks so much for your help!

    Tristan

Children
No Data

Before You Switch


Switching languages will make ADI Explorer unavailable. Resume your session by switching back to English and reopening ADI Explorer.