Original Question: How to configure the sensor on Bunch WSN? by warrensuoqi
Hi Sir!
I have bought EV_ADRN_WSN_1Z. There are two Multi-Sensor Node Boards. One of them is factory-seted to a Triple Axis Accelerometer and anothe to a Humidity&Temperature Sensor. The "ANODE CENTER POINT" can only show limited sensor data as follow figure:
But there are many other sensors on the board. I want to know how to configure them.
Thank you!
Verified Answer: RE: How to configure the sensor on Bunch WSN? by harishkumarkatam
Hi warrensuoqi,
I observe that you are using very old version of the ADRadioNet software on the EV-ADRN-WSN-1Z (Bunch) boards. Please download and install the latest version (ADRadioNet Software ADuCRF101 free, with new PC Tool Rev 2.0.1) of ADRadioNet software from the below location.
After installation refer to all “ADRN01-All-in-One-GettingStartedGuide-v2.0.1.pdf” in the Docs folder for the information on how to flash the nodes and setup the demo with different on board sensors.
You can also run AD6LoWPAN protocol on EV-ADRN-WSN-1Z boards, from the above link the package can be downloaded (AD6LoWPAN Software – ADuCRF101 free (Rev 1.0))
Hope this helps
Thanks & regards
Harish kumar k