Original Question: Default configuration for AD6LoWPAN devices by NagarjunaG
My devices are not working. How do I get back the factory default configuration of a device? What are the default configurations used in the demo setup for each of the devices?
Verified Answer: RE: Default configuration for AD6LoWPAN devices by NagarjunaG
The default configuration for any AD6LoWPAN device can be obtained by clicking the “Factory Default” button in the Configuration window of ADWSN-UI tool. Once the device is detected, select that device and click “Factory Default” tab as shown below.
If you load the firmware afresh on the device and bring it up, it comes up with the factory default configuration. The user then can configure the device manually as desired.
The default configuration parameters used in the AD6LoWPAN demo setup are as shown below:
|
Attribute |
Default Value |
Remark |
|
MAC Address |
6LBR : 0x0005f7feff000001 6LR : 0x0005f7feff000002 6LN : 0x0005f7feff000003 |
Unique IEEE Address used by device for communication |
|
ISMBand |
ISMBAND_863_870MHZ |
Operating frequency band |
|
PHY |
Operating Mode 1: 50 kbps 2FSK |
Operating data rate and modulation |
|
Channel |
0 |
Operating channel |
|
Tx Power |
63 |
Transmit Power |
|
Sleep Time |
1 (Applicable only for Nodes) |
Node’s periodic sleep time in seconds. |
|
Orbit |
1 (Applicable only for Nodes and Routers) |
Specifies the parent’s orbit at which the node shall attempt to join. |
Question: RE: Default configuration for AD6LoWPAN devices by ezadminThis question has been closed by the EZ team and is assumed answered.