ADWSN-UI tool displaying "unknown device" on my centerpoint node

Hi Yoshimasa,

I hope you are trying to evaluate AD6LoWPAN demo. The “Unknown device” problem may occur due to the following reasons

• The device driver for USB-SWD/UART-EMUZ board is not installed properly
• UART communication error
• Binaries used to flash the devices are not proper.

In your case, I suspect the binaries flashed on to the devices are not proper, as BUNCH WSN boards are detected as “Endpoint”. The ADWSN-UI tool will detect AD6LoWPN devices as Border Router, Router and Node. The ADWSN-UI tool may detect devices with different firmware as “Unknown device” when multiple devices are connected to it.

Flash all the boards with the latest binaries and then try connecting. If the problem still exists follow the below post in Engineer Zone, for reasons and solutions for detecting the devices as unknown devices.

https://ez.analog.com/message/207045#207045

Please follow the below link to know the information about the factory default settings and the default binaries flashed on to the devices, you received in the Development Kit.

https://ez.analog.com/message/207267#207267

Please refer to the “AD6LoWPAN-All-in-One-GettingStartedGuide” document supplied with the package, on how to flash the firmware. After following the above steps if the problem exists please revert back with the following information.

• Number of devices connected to the tool
• Version of Binaries flashed
• Provide configuration window screen short of ADWSN-UI tool, which shows the devices detection.

Thanks & Regards

Harish kumar k

Hi Yoshimasa,

I hope you are trying to evaluate AD6LoWPAN demo. The “Unknown device” problem may occur due to the following reasons

• The device driver for USB-SWD/UART-EMUZ board is not installed properly
• UART communication error
• Binaries used to flash the devices are not proper.

In your case, I suspect the binaries flashed on to the devices are not proper, as BUNCH WSN boards are detected as “Endpoint”. The ADWSN-UI tool will detect AD6LoWPN devices as Border Router, Router and Node. The ADWSN-UI tool may detect devices with different firmware as “Unknown device” when multiple devices are connected to it.

Flash all the boards with the latest binaries and then try connecting. If the problem still exists follow the below post in Engineer Zone, for reasons and solutions for detecting the devices as unknown devices.

https://ez.analog.com/message/207045#207045

Please follow the below link to know the information about the factory default settings and the default binaries flashed on to the devices, you received in the Development Kit.

https://ez.analog.com/message/207267#207267

Please refer to the “AD6LoWPAN-All-in-One-GettingStartedGuide” document supplied with the package, on how to flash the firmware. After following the above steps if the problem exists please revert back with the following information.

• Number of devices connected to the tool
• Version of Binaries flashed
• Provide configuration window screen short of ADWSN-UI tool, which shows the devices detection.

Thanks & Regards

Harish kumar k