Hi Ramya,

The extra data you see other than sensor is statistics. To disable statistics send a “Disable Statistics” command to the Node from the Border Router that should work. Please see the below figure for the information on how to send command to a node. This information is already provided in the Monitoring & Control section of “AD6LoWPAN-All-in-One-GettingStartedGuide_v1.0”.

Note: Ensure to select the correct node address and make sure the node is not in sleep state before sending the command.

2086.64ab9b9520398295c09fc42cbb00941e.jpg

Thanks & Regards

Harish kumar k

Hi  Harish,

Thank you for your reply, when i tried to do the same, the Disable Statistics command was not found.

6175.5f2e55e6b2c68989d6981ec24b5f4b57.png

Hi Ramya,

This option is provided in the AD6LoWPAN02 release supported on EVAL-ADuCM3029 EZ-KIT Hardware, you can edit the code to achieve this on BUNCH board. The “Add_SensData2Payload” function in ADSens-Main.c file adds the sensor data and statistics to the payload buffer. Comment the statistics code part at end of the function after the “SensorMask” addition. This should work.

thanks & regards

Harish kumar k

Hi Harish,

Thank you very much for your suggestion, the pay load length is been reduced. 2844.fca09634910d45ae04ff135e2a68fc95.png

I could not decode what  does 1B FF FF FF FF AA AA 56 78  and the data after Mac ID, that is FF FF FF FF 0B 04  is conveying.

Thanks

Ramya

Hi Ramya,

Please go through the below link for the information on header, the data you are seeing other than MAC address and port is not over the air data, Border Router adds this information and sends it in the format the generic ADWSN-UI tool  understands. At present most of it are dummy values, the marked fields in the link are important.

https://ez.analog.com/thread/67632

thanks,

Harish