adrv9008-1 profile TES

The default on board VCXO is 122.88MHz and DEV_CLK frequency should be an integer multiple of that. If you want to use 100MHz DEV_CLK then you have replace the onboard VCXO accordingly to the one that you have set in the filter wizard and then load it into GUI and initialize.

The default on board VCXO is 122.88MHz and DEV_CLK frequency should be an integer multiple of that. If you want to use 100MHz DEV_CLK then you have replace the onboard VCXO accordingly to the one that you have set in the filter wizard and then load it into GUI and initialize.

I have set in the wizard and then load it into GUI and initialize, I set device clock 100MHz in the wizard, but it always keep 122.88MHz after load and initialize GUI.

It is strange, When I set the device ADRV9008-2 and setd clock 100MHz, after loading it display 100MHz on the GUI.

without connected to the board，why i can set 100MHz DEV_CLK when i use ad9009/9008-2，but cann't use 9008-1?

Change the on board default VCXO of 122.88MHz to 50MHz. Then connect to the board using TES GUI. Load the profile that you have generated and then program.

The DEV_CLK needs to be an integer multiple of the VCXO freq. refer below link:

https://ez.analog.com/wide-band-rf-transceivers/tes-gui-software-support-adrv9009-adrv9008-1-adrv9008-2/f/q-a/164911/reference-clock-for-adrv9009/372960#372960 

Do you mean I have to connect the board to use this software? I just want to use it to generate the init. C file and debug it with the board a few days later.

I configure VCXO freq to 50MHz and DEV_ CLK to 100MHz, DEV_ CLK is an integral multiple of VCXO freq, but TES still displays DEV_ CLK is 122.88mhz by default but not 100MHz

Share with us the config file that you generated from filter wizard using insert option in command window.