We used an RF splitter to inject the same signal in to both RX1 and RX2. We were expecting the displayed time domain for RX1 and RX2 to be locked to each other, but it appears the data for each ADC is collected at a different instant in time. Is this correct? Is there away to configure the evaluation board for dual channel coherent signal collection?
Are you using TES GUI to capture? Can you please share screenshot of your issue?
Hope you are enabling RF Phase synchronization.
And also make sure you are having the same cable length for routing RX1 and RX2.
This shows the receiver data output and RX1 is not coherent with RX2.
The cables from the splitter to RX1 and RX2 are equal length
The time domain RX1 and RX2 waveform change phase between 0 and 180 degrees with each screen refresh.