I have just ADRV9371-w/PCBZ cards from analog devices and FPGAs zc 706 from Xilinx.My first step is to use my cumputer to control one ADRV9371 card conected and FPGA to transmit something.I use Wide Tuninig Range AD9371 Eval Brd Tranceiver Evaluation Software.
I capture signal through receiver channel Rx1 and Rx2, but data is saving equally.
Can someone help me?
Thank you for your answers
The Rx1 & Rx2 seem to be configured with the same parameters [frequency & other stuff].
It is normal to get the same data on both.
If you need to configure RX1 different than RX2, you can use
I'm not sure about the Wide Tuninig Range AD9371 Eval Brd Tranceiver Evaluation Software.
travisfcollins or mhennerich
When saving data, only the data is saved RX1 channel, RX2 data are not recorded, instead written to the data Rx1.
I think this was a bug that got fixed. Vinod or srimoyi have you seen this?