Important: For full functionality of this site it is necessary to enable JavaScript. Here are the instructions how to enable JavaScript in your web browser.

Mixed-Signal Front Ends (MxFE)

Q&A No power to AD9082-FMCA-EBZ with ADS9-V2

Mixed-Signal Front Ends (MxFE) requires membership for participation - click to join

State Verified Answer
+1 person also asked this people also asked this
Replies 2 replies
Subscribers 3 subscribers
Views 130 views
Users 0 members are here

Options

Related

No power to AD9082-FMCA-EBZ with ADS9-V2

Davey on Sep 16, 2021

I have the same issue as https://ez.analog.com/wide-band-rf-transceivers/mixed-signal-front-ends-mxfe/f/q-a/540761/no-power-to-ad9082-fmca-ebz-a2-with-ads9-v2/425646#425646

When I click on the AD9082 icon, the power LEDs blink twice extremely briefly, but never stay on. Then ACE reports a Checkstate failed

I have reinstalled ACE and the plugin, but no change in status.

Top Replies

Davey Sep 17, 2021 in reply to PMH +1 verified

The uZED board jumpers were correct,

however, the ADS9-V2 board Boot SEL switch was in the OFF position. When changed to the ON position, the AD9082 board now receives power.

0 PMH

on Sep 16, 2021 6:37 PM
Hello,

Can you check if the jumpers on the uZED card are correctly such communication to the device is via the uZED card. With the jumpers of the uZED board positioned in the top left corner of board...................the 1st jumper (furthest to left) should be pointing down while the 2nd and 3rd jumper shold be positioned up. Let us know if problem persists.
Cancel
Up 0 Down

Reply

Verify Answer

Cancel
+1 Davey on Sep 17, 2021 3:37 PM in reply to PMH

The uZED board jumpers were correct,

however, the ADS9-V2 board Boot SEL switch was in the OFF position. When changed to the ON position, the AD9082 board now receives power.
Cancel
Up +1 Down

Reply

Reject Answer

Cancel