Hello
I consider to connect the AD9364, placed on a custom made board with Raspberry Pi 4 in the following way:
1. Raspberry PI SPI interface will be used for communication with AD9364
2. Raspberry PI GPIO pins will be connected to the AD9364 GPIO pins. A HW conversion to/from 3.3V/1.8V voltage levels will be implemented in HW
Do you see any issue with such implementation?
Thanks.
You can use SPI interface for communication with AD9364.
Make sure that the setup and hold times are met as per datasheet:
Note that our chip supports LVDS/CMOS data interface.
Raspberry PI GPIO pins will be connected to the AD9364 GPIO pins
Yes, this can be done
A HW conversion to/from 3.3V/1.8V voltage levels will be implemented in HW
Make sure the power supply is able to provide the current specs as mentioned in datasheet.
You can use SPI interface for communication with AD9364.
Make sure that the setup and hold times are met as per datasheet:
Note that our chip supports LVDS/CMOS data interface.
Raspberry PI GPIO pins will be connected to the AD9364 GPIO pins
Yes, this can be done
A HW conversion to/from 3.3V/1.8V voltage levels will be implemented in HW
Make sure the power supply is able to provide the current specs as mentioned in datasheet.
