Design Support AD9361/AD9363/AD9364

Discussions Interfacing AD9361 with a different FPGA

Interfacing AD9361 with a different FPGA

Jobin

on Dec 19, 2018

We were using PicoZed SDR board and have experimented our digital tranceiver application with matlab simulink generated code.

Right now , we want to interface with a different FPGA in our own board. We have the IPs of the Tx/Rx logic for this FPGA.

How can we configure the AD9361 from our FPGA? How can we send/receive complex i/q values with AD9361.

Is there any step by step tutorial available?

Parents

AdrianC

on Dec 19, 2018 9:32 PM
Hello,

We have a guide or porting a project to a different carrier / FPGA:

https://wiki.analog.com/resources/fpga/docs/hdl/porting_project_quick_start_guide

If you have a Xilinx FPGA and enough resources to port the project completely, you probably can use the exact software to configure the part and send/receive data.

There is no step by step tutorial on how to do this, the above link should be a good starting point.

Regards,

Adrian
Cancel
Up 0 Down

Reply

Cancel

Reply

AdrianC

on Dec 19, 2018 9:32 PM
Hello,

We have a guide or porting a project to a different carrier / FPGA:

https://wiki.analog.com/resources/fpga/docs/hdl/porting_project_quick_start_guide

If you have a Xilinx FPGA and enough resources to port the project completely, you probably can use the exact software to configure the part and send/receive data.

There is no step by step tutorial on how to do this, the above link should be a good starting point.

Regards,

Adrian
Cancel
Up 0 Down

Reply

Cancel

Children

No Data