Post Go back to editing

Question on how to receive ORX data through JESD after DPD operation in ADRV9029

Category: Software
Product Number: ADRV9029
Software Version: SW6.2.0.35

It is set to 3pin ORx Selection mode as shown in the figure below.

However, although I enabled it on the RXx_en pin, ORx Data is not coming in through JESD.

I know that no ORX data is coming out through JESD during DPD operation.

But I want to receive ORX data through JESD when DPD operation is finished, please advise on how to control it.

Thank you for your support.



add
[edited by: Justin.Jung at 2:23 AM (GMT -4) on 27 Jun 2022]

Top Replies

Parents Reply
  • How should I control the value of the part circled in red in the picture above?

    1) ORx2_Tx_SEL, ORx4_Tx_SEL

    2) ORx1_Tx_SEL, ORx3_Tx_SEL

    3) ORx1_Tx_EN, ORx2_Tx_EN, ORx3_Tx_EN, ORx4_Tx_EN

    Even when ORX_CTRL_A is set to high, the customer says that Rx data comes out through JESD, but ORx data does not come out through JESD.
    Any advice on what could be the problem?

    Please advise.

    Thank you.

Children