ADRV9026 ORX pin control

Hi ADI:

I want to setting ORX to pin mode . I choose Single Channel 1 Pin Mode,  and want to enable all orx channel 

In the Table 112 in UG1727, it statements a single channel is selected through the API ,

Could you tell me what is the API? And is it possible to enable 4 orx ports simultaneously? 

Thanks a lot~

-----------------------------------------------------------------------------------------------------------------------------------------------

 UG1727 Table 112:

Single Channel
1-Pin Mode In this mode a single channel is selected through the API (over SPI). ORX_CTRL_A is the enable/disable control pin,
when high the selected ORx is enabled, when low, all ORx paths are disabled. Figure 57 illustrates Single Channel 1 Pin
Mode. Note that ORx1 has been shown in this example, however any of ORx1 to ORx4 can be chosen.

Parents
  • Once the enable pin is high and the ORX1 is enabled through API, ADI_ADRV9025_SINGLE_CH_PIN_MODE_ORX1_FE ; then ORX1 is selected.

    Similarly when the enable pin is high and if ADI_ADRV9025_SINGLE_CH_PIN_MODE_ORX2_FE is enabled, ORX2 path is selected.

    Could you tell me what is the API? And is it possible to enable 4 orx ports simultaneously? 

    Page 111 of the UG has the API details, snapshot below; One only ORX channel can be enabled at a time.

Reply
  • Once the enable pin is high and the ORX1 is enabled through API, ADI_ADRV9025_SINGLE_CH_PIN_MODE_ORX1_FE ; then ORX1 is selected.

    Similarly when the enable pin is high and if ADI_ADRV9025_SINGLE_CH_PIN_MODE_ORX2_FE is enabled, ORX2 path is selected.

    Could you tell me what is the API? And is it possible to enable 4 orx ports simultaneously? 

    Page 111 of the UG has the API details, snapshot below; One only ORX channel can be enabled at a time.

Children