I am using ZCU102 Rev 1.1 + ADRV9009. However, I am not using ARM cortex-A53 for configuring ADRV9009. I have connected myself design microprocessor with AXI to SPI which is linked to SPI ADRV9009 board. My micropocessor runs on frequency 100Mhz. Everything is fine with SPI. However, it raise an error related to check sum like following picture:
Is this problem raised because my microprocessor running too slow?
I think it may be a good idea to post this question on this sub-forum:
It looks to me that you are using the 9009 very differently than our reference design.
Redirected question to Design Support forum for 9009.
Can you share with us the cal that is failing by reading back the below API:
I checked and found that it stop in the marked function.
Can you reduce the SPI speed to 10MHz and then try?
Can you read and write the scratch pad register 0x00A 5k times and then check if al the read writes are fine.
Also, can you share with us the error log?