Step 5 of the "Setting Up the Evaluation Board" section of UG-1378 (Rev 0) says to connect a 6V power supply to the P501 header of the ADR9009 evaluation board. The schematic (Rev B) for the ADRV9009-W/PCBZ doesn't show this connector. The schematic makes it look as though all power comes through the FMC.
For clarification, I do not have this eval board and am only looking at documentation.
Where is P501?Am I looking at old documentation?
There is a mistake in that statement in UG-1378.Donot consider that step.
Schematics are correct. You do not have to connect a power supply to EVB.