We want to use ADRV9002 Eval board with ZCU106 FPGA.
First we generated hardware reference design by following steps wirtten here .-> https://wiki.analog.com/resources/eval/user-guides/adrv9002/reference_hdl ( Note that it is configured for ZCU106)
Then for bare-metal test, a software platform is created as written here -> https://wiki.analog.com/resources/eval/user-guides/adrv9002/no-os-setup
This created test environment works fine and we can see spectrum of signal which is provided by LUT in DAC_DMA_EXAMPLE.
The next step was, building this test environment on linux instead of bare-metal. For this purpose, we followed steps written in this page -> https://wiki.analog.com/resources/tools-software/linux-drivers/iio-transceiver/adrv9002 and we achieved successfull result as in bare-metal test.
Due to ease of use we decided to connect FPGA and configure parameters by using TES GUI. At this point we got Connection Failure on TES. An image related with this error is attached below.
Does this TES GUI work only with supported FPGA's (ZCU102 and ZC706) or can it work with other FPGA's as well? If it can work with ZCU106, what is the key point we missed?