Post Go back to editing

Enabling the LOL correction algorithm in adrv9361z7035

Category: Software

Dear all;

I am using the adrv9361z7035 breakout board. I want to know the LOL algorithm enabling for internal and external LOs. When I set the Tx and Rx LO at the same frequency and I got the Tx LO leakage with -2 dBm signal in Rx side. For removing this leakage, I increase the Tx attenuation and problem somehow resolved, but increasing Tx attenuation new problem is faced which is Tx signal strength goes down which is bad for me. After this conclusion I reached at this point to enable LOL correction algorithm for internal. How I can did this job?   

Please help needed.

Thanks 

wm-wm



Tilte
[edited by: wm-wm at 5:30 AM (GMT -4) on 11 May 2022]