Dear Team ,
we are working with AD9371 along with ZCU102 .The chip is getting initialised without any error .But Transmitter outputs are not coming . we tested it it by enabling the internal NCO also ,still it is not working . The same configuration files are working for another AD9371 eval board .What could be the reason for this .
Thanks and regards
Is the transmission failing for AD9371 eval board or custom board? If, it is eval board , then check for any physical damage on the board.
Are you using IIO GUI for configuring the chip?
If it is custom board, check for the Balun power supply. Are you getting signal at RX output?
It is eval board .Can you please tell the areas where we should focus for Physical damage check .
No we are not using IIO GUI
yes RX outputs are coming .
Check if the TX path Balun is properly attached to the board or not. Check if you are getting any output at TX port2.