Using MEMS Accelerometers for Condition Monitoring

Sep

2016

This webinar has already aired but can still be accessed through the Watch the Webinar button below.

Ed Spence Marketing Manager

Condition monitoring is a major component of predictive maintenance. This webcast will highlight the benefits that MEMS Accelerometer technology brings to Condition Monitoring. Intrinsic attributes of MEMS that make a compelling case with respect to the liabilities of alternative technologies will be discussed. Also, progress with regard to performance will be reviewed, with comparisons to accelerometer technology commonly used today.

Electronic Design Services - PartnerZone

Using MEMS Accelerometers for Condition Monitoring

About the Webinar

9/21/16 What temperature are typically critical for accelerometers? How big is the ppm drift typically? +1

9/21/16 You mentioned about Gen2 accelerometers with 30ug/root Hz.....Could you give us an example of such product? +1

9/21/16 Are there any changes needed to the CM algorithms to support MEMS devices? +1

9/21/16 What supply voltage is used for gen2? +1

9/21/16 How stable is sensitivity over life time? +1

9/21/16 How does magnetic or electric field affect MEMS accelerometer measurements? +1

9/21/16 What about the sensitivity variation above 1kHz? Is it similar? +1

9/21/16 Is there availability on the Upgraded 2016 accelerometers replacing vintage AFDXL001s? +1

9/21/16 I observed that the offset drift problem over time will effect the performance. +1

9/21/16 Does the accuracy of accelerometers suffer with age? +1

9/21/16 What is the typical power consumption of a MEMS accel. solution? +1

9/21/16 For optimal high frequency response, are there app notes on how to mount on PCB and mechanically couple to the mounting? +1

9/21/16 For 1-2 Hz applications it still looks like the noise is higher for MEMS. Will low frequency noise performance get better in the future? +1

9/21/16 Are any MEMS sensors compatible with an IEPE interface? +1

9/21/16 For condition monitoring is 1-axis enough or needs 3-axis? +1

9/21/16 How do I make sure I buy the new technology? Model numbers, marketing names, etc. +1

9/21/16 Can these be printed on a device surface? +1

9/21/16 Is there any chance to improve technology to increase the temperature range? +1