As pointed out in the webinar I was trying to perform Simulation of LNA, HMC374/ 374E using ADS. I would like to get clarified on how to perform two-tone simulation using the Amp2 model in ADS. I have observed that on performing two-tone simulation, the "GainCompressionFrequency" in Amp2 model takes a single frequency and hence Gain Compression is observed on only that frequency. So while performing an n-tone simulation, the gain compression is happening only at a single frequency which is entered in "Gain Compression Frequency" column,and the other frequencies are not taken into account. So, I would like to get clarified on how to perform two tone simulation in ADS using the Amp2 model after importing the non-linear data of the LNA from Genesys.