How to control exposure time of KAI-29050 using GPO1 in AD9928

Hi,

Apologies, I know this is long overdue. However, we are clearing some open items and ensure that someone who have similar issue may find this helpful.

I am suggesting to move this thread to its proper community https://ez.analog.com/video/f/q-a. Someone here may assist this.

One thing to note here is that this product is not recommended for new designs, comparable products can be seen here.

https://www.analog.com/en/parametricsearch/11269#/ 

Thanks,

Jellenie

Hi,

 There is separate forum for ADCs group Precision ADCs
 Could you please post your question there where you will be more likely to get a knowledgeable answer.
Please note that, we do not have any reference settings for this CCD. It's possible that On-Semi might have something for a similar CCD.
Try checking the RG drive and RG mask register settings to make sure they are all programmed correctly. Also, any Sequence registers that are not used should always be set to 0x0 to avoid any unintended masking behavior.
The V-clocks should be debugged with the CCD disconnected.

Thanks,

Poornima

Hi,

 There is separate forum for ADCs group Precision ADCs
 Could you please post your question there where you will be more likely to get a knowledgeable answer.
Please note that, we do not have any reference settings for this CCD. It's possible that On-Semi might have something for a similar CCD.
Try checking the RG drive and RG mask register settings to make sure they are all programmed correctly. Also, any Sequence registers that are not used should always be set to 0x0 to avoid any unintended masking behavior.
The V-clocks should be debugged with the CCD disconnected.

Thanks,

Poornima