ADV7611 impedance + IBIS file

Question

I'm looking for the IBIS file of the ADV7611 to determine the output impedance of the data lines. I already tried the following link but this end in a 404 error page. 
 The reference designs don't give me clear answers. As example the schematics of the ADV7311 evaluation board are using 75 ohm resistors and 75 ohm traces for the data lines. In other reference designs the are using 22 Ohm or 33 Ohm resistors. I would like to see which value is mentioned in the IBIS file. 
 I want to use 33 Ohm resistors for the datalines because I also want to use the ADV7180 on the same data bus (not simultaneously of coarse, one of the devices will be in tri-state). The ADV7180 has a typical impedance of 35 ohm. 
 Please help.

GuenterL · Accepted Answer

I've attached a temporary ADV7611 IBIS file to 
 ADV7611 Design Support Files 
 The board impedance for the reference design was 75 Ohms therefore the 75 Ohm resistors. The 75 Ohm board impedance was pick to handle the analog video easier. 
 Normal boards are 50 Ohm impedances so 22 - 33 Ohm series resistors are prefect. You only need to watch out how you handle the incoming 75 Ohm impedance analog video signals. They should remain 75 Ohms until the resistor divider so you don't get any impedance mismatches.

Electronic Design Services - PartnerZone

Products In This Thread

ADV7611 impedance + IBIS file