Post Go back to editing

Video Decoder( ADV7282A) outputting noise instead of Blue screen

Thread Summary

The user is experiencing issues with the ADV7282A video decoder where the output becomes unstable and causes a black screen when the CVBS signal is noisy or degraded. The final answer suggests checking the current register settings and verifying signal levels during the issue scenario. The user has already tried adjusting gain and filter values but seeks a solution to maintain stable EAV/SAV outputs and continuous sync codes, similar to the ADV7842's free-run mode without displaying a test pattern.
AI Generated Content
Category: Hardware
Product Number: ADV7282A
Hi Sir .
We use the ADV7282A video decoder in our product. The system architecture and signal flow are shown below 
RF Tuner ---> CVBS --->   ADV7282A ---> TTL to TMDS (Bridge IC) --->   HDMI receiver of Scaler .  
 
Our Monitor shall continue to display with low or distorted CVBS signal as illustration below   
As signal degrades, static is acceptable, but the monitor should not blank to a blue/black screen 
Therefore, we must configure the ADV7282A in free-run mode without a test pattern; otherwise, the bridge IC and scaler will be lock lost ,
eventually leading to a black screen .  We used the ADV7842 for a different product that support this features ("If in free run output decoded video data") as illustration below 


 
Can the ADV7282A support this, or is there an alternative way to achieve our requirement? Or are there other alternative video decoders we could adopt? 
 
Parents
  • Hi ,

    Thank you for providing the additional information.

    Could you please provide an update on the following items?

    1. What is the analog input signal amplitude level during the noisy image condition and the blank video condition (when the drone flies far away)?
    2. Kindly share the system register dump captured during the blank output condition.
    3. What is the measured LLC frequency values in both cases?
    4. Please provide the P0 to P7 signal levels measured using an oscilloscope (CRO) during both the working and issue conditions.

    Your feedback on the above points will help us further analyze the issue.

    Thanks,

    Ebin

Reply
  • Hi ,

    Thank you for providing the additional information.

    Could you please provide an update on the following items?

    1. What is the analog input signal amplitude level during the noisy image condition and the blank video condition (when the drone flies far away)?
    2. Kindly share the system register dump captured during the blank output condition.
    3. What is the measured LLC frequency values in both cases?
    4. Please provide the P0 to P7 signal levels measured using an oscilloscope (CRO) during both the working and issue conditions.

    Your feedback on the above points will help us further analyze the issue.

    Thanks,

    Ebin

Children
No Data

Before You Switch


Switching languages will make ADI Explorer unavailable. Resume your session by switching back to English and reopening ADI Explorer.