PC/MC

Question

If i try to flash one of the skripts i get the message to switch the MC/PC switch to PC but i cant find the switch. (looked threw the manuals but coudnt find it. On the board i only found the reset and powersupply switches) 
 Can someone help me here?

PoornimaSubramani · Accepted Answer

Hi, 
 --> Please check the below options are set, as shown in figure and then click the OK button. --> When the register control software starts, it firstly initializes all the selected devices and then loads the reset defaults for each device. 
 -->I2C control and reset signals are connected to the evaluation board through the USB cable. This USB cable should be connected to the evaluation board before the application software is started. 
 
 Thanks, 
 Poornima.S)

Partner Forums

Partner Libraries

Products Mentioned

PC/MC