About ADV212 configuration

Question

Regarding to the -stepsize configuration. 
 
 In the mannual, it said this parameter shall be configured before soft reboot, and then set Load_ss to 1, when we followed this procedure, it always fails. 
 
 We found ADV still use the default parameter, the configuration is not valid. 
 
 Please help on this, thank you for your promptly reply!

PoornimaSubramani · Answer

Hi, 
 Please note that, After firmware loads with new step sizes and this bit is again reset to '0'. Also as per expert comment, We can realize these step sizes controls only very subtle impacts on the image and it won't be very obvious. 
 
 Thanks, 
 Poornima

Electronic Design Services - PartnerZone

Products In This Thread

About ADV212 configuration

Top Replies