Category: Datasheet/Specs
Product Number: ADV748x
Hi,
I have a question about a tolerance(accuracy) of 100kohm pull-down resister for RX_5V pin of ADV7480.
The H/W manual say as follows on the page142.
>Important: When using the RX_5V/VBUS pin on the ADV748x, a large pull down resistor (100kΩ typical) to ground should be connected to this pin.
Question:
Is there any required tolerance (accuracy) for this 100kohm resister?
My customer had used ADV7480 for their system, and he used 100kohm plus-minus 5% resister for the RX_5V pin.
Is the 100kohm plus-minus 5% resister allowed for the pull down resistor of the RX_5V pin?
Thank you!
Best regards.
Tamu
