Post Go back to editing

[ADV748x] Tolerance (accuracy) of 100kohm pull-down resister for RX_5V pin

Category: Datasheet/Specs
Product Number: ADV748x

Hi,

I have a question about a tolerance(accuracy) of 100kohm pull-down resister for RX_5V pin of ADV7480.

The H/W manual say as follows on the page142.
>Important: When using the RX_5V/VBUS pin on the ADV748x, a large pull down resistor (100kΩ typical) to ground should be connected to this pin.

Question:
Is there any required tolerance (accuracy) for this 100kohm resister?
My customer had used ADV7480 for their system, and he used 100kohm plus-minus 5% resister for the RX_5V pin.
Is the 100kohm plus-minus 5% resister allowed for the pull down resistor of the RX_5V pin?

Thank you!
Best regards.
Tamu

Top Replies

  • FormerMember
    FormerMember
Mar 16, 2023 +1 verified

Any tolerance will work

Parents
  • FormerMember
    +1 FormerMember
on Mar 16, 2023 9:15 AM

Any tolerance will work

Reply
  • FormerMember
    +1 FormerMember
on Mar 16, 2023 9:15 AM

Any tolerance will work

Children