when adv7481 bringup in our board, then we used SONY DV HDR-CX405 as input.
if the DV is set 720P, then the data after adv7481 is okay. but if the DV is set to 1080P, then the data after adv7481 is broken as attached, and it could keep long time with such kind broken data.
so that is the same DV, but differnet set leads to differnt result. I checked the datasheet, it seems to support 1080P with HDMI interface. and the kernel log shows adv7481 can detect the right size from HDMI.
adv7481_get_hdmi_timings(2035), adv7481 TMDS Resolution: 1920 x 1080 @ 60 fps
could you help to check and share some clue? Thanks so much.
This progressive format is not possible in 2-lane. But we can support for interlaced one.
Hi, In your configuration,output video seems like 4:2:0 format. But we don't see any 4:2:0 conversion in ADV7481 part.Please refer ez.analog.com/.../adv7481-design-support-files
Note: The video data output by the HDMI/MHL section is always in a 4:4:4 format with 36 bits per pixel.This is irrespective of the encoding format of the video data encapsulated in the HDMI/MHL/DVI stream input to the HDMI/MHL Rx section (that is, 4:2:2 or 4:4:4).
Thanks for your reply. the screenshot is the HDMI section + ISP process. so that you saw it's 4:2:0.
actually we configured as the guide said, and tested with this SONY DV, 720P is okay, and the the preview on screen is good. but 1080P is broken as above.
I am not sure if there is some config or setting could adjust to make it work well, could you share some guide or clue?
thanks a lot.
Please refer below script for 1080 configuration,whether you may miss anything for 1080p.
Thanks Poornima, I will have a try to check the different between current setting the reference.
Our board is designed with 2-lane - YUV422 8-Bit. the input size is HDMI in with 1080P.
I checked the ADV7481 Required Settings, there is no matched setting for our case in https://www.analog.com/media/en/engineering-tools/design-tools/ADV7481ES3C-VER.3.6c.txt .
and I tested with below setting:
; Supported Formats For Script Below - 720x480p60, 1280x720p60, 1920x1080i60, 720x576p50, 1280x720p50, 1920x1080i50, 800x600(SVGA)@60, 640x480(VGA)@60, 800x480(WVGA)@60, 1024x768(XGA)@60:01-11 HDMI to MIPI TxA CSI 2-Lane - YUV422 8-Bit, Up to 600Mbps:
but still got the same issue.
and I'd like to show the point of my issue, the 720P is okay, but 1080P has different result with several devices, some one shows OK, some shows with lots of green lines, somes shows the broken data.
could you help to check this?