Video

Q&A

by JoK
Video

Started 7 hours ago
19 0 0
Not Answered
Faulty DDC communication between ADV7619 as receiver and PC 0
Not Answered

I am using the ADV7619 as a video receiver. It is connected to a PC as the image source via an HDMI cable. I use the following register configuration :02-01 480i,576i,480p,576p In - 24-bit RGB 444 Out: as written in ADV7619-VER.1.9c.txt angegeben...

software edid HDMI/DVI Receivers HDMI/DVI Devices adv7619 hdmi Show More

19 0 0
by PMC
Video

Latest 10 hours ago by Ebin
834 38 0
Not Answered
ADV7181C Register Settings for STANAG3350 Signals 0
Not Answered

Hello ADI Team, We are using ADV7181C video decoder with STANAG3350 B inputs. With the auto detect option register settings, when we give are seeing slight jitter on the image. But if we try signals from an NTSC based signal (STANAG 3350 C), then we...

Video Products adv7181c hardware Video Decoders

834 38 0
by jianzhou
Video

Latest 20 hours ago by jianzhou
170 7 0
Not Answered
The image is not centered and doesn't fill the screen. 0
Not Answered

Dear Engineer, I am currently debugging the ADV7280A-M, configured for CVBS autodetection with progressive output (I2P), single-ended input on AIN3, and 480p/576p MIPI output . The image captured by the backend processor is not filling the entire...

Video Products adv7280a software Video Decoders ADV7280A-M configuration Show More

170 7 0
by ankitsohni
Video

Latest 1 day ago by Ebin
56 1 0
Not Answered
Analog CVBS PAL to MIPI CSI 2 AND MIPI DSI 2 to Analog PAL conversion Chip 0
Not Answered

We have NXP processor i.MX 8M PLUS which accepts video over MIPI-CSI-2 interface. Analog Video (PAL) is required to interface with the processor. We have searched about ADV7282A-M which has MIPI Tx in-build into ASIC chip. Whether SDTV decoder...

Video Products adv7282 hardware Video Encoders Video Decoders Show More

56 1 0
by kjrajendraprasad
Video

Latest 1 day ago by kjrajendraprasad
492 16 0
Not Answered
Query on Black bands seen with ADV7281 0
Not Answered

Currently we are using ADV7281A in our design where we have a source which is sending 720x480i input to the ADV7281A. We have configured ADV7281A to output BT.656-3 480i, And, we are receiving 720x253 (even field) and 720x254 (odd field) at the SOC...

Video Products hardware adv7281a Video Decoders

492 16 0
by 3hl3rt
Video

Latest 1 day ago by Ebin
40 1 0
Not Answered
advice on low-latency composite video to HDMI/DP chain (ADV7280 + transmitter) 0
Not Answered

Hi, I’m working on a design where I need to handle three analog composite (CVBS) input channels. The system must be able to select one of the three inputs and convert it to digital video with as low latency as possible. So far we have **ADV7280...

hardware HDMI/DVI Transmitters HDMI/DVI Devices

40 1 0
by Safran
Video

Latest 2 days ago by Safran
240 10 0
Not Answered
Entering in free run mode when I switch between 2 video souces 0
Not Answered

Hello, I Uses a ADV7181C with 2 RGB cameras. I need to switch between camera 1 to camera 2 and vice versa very often (2 or 3 seconds). From time to time, the ADV7181C entered in free run mode and provide a blue video. To quit this state, I need to deconnect...

Video Products adv7181c software free running Video Decoders Show More

240 10 0
by LukaszP
Video

Latest 2 days ago by Ebin
38 3 0
Not Answered
Evaluation board BoM 0
Not Answered

Dear Sirs, would it be possible to share BoM for EVAL-ADV7630 evaluation kit with me please? Kind regards Lukasz Poradowski

hardware EVAL-ADV7630 HDMI/DVI Receivers HDMI/DVI Devices adv7630 Show More

38 3 0
by dtt
Video

Latest 2 days ago by Ebin
206 5 0
Not Answered
Luma dynamic range sometimes shrinks 0
Not Answered

Hi, So I'm trying to use ADV7180A to digitise an inherently unstable and noisy analog video. The source is CVBS, input network is as specified in the data sheet (24 and 51 Ohm resistor and 100 mF capacitor). I'm using the built-it linux driver (kernel...

Video Products software Video Decoders adv7180

206 5 0
by Ashish
Video

Latest 3 days ago by Ebin
91 4 0
Not Answered
ADV7181DWBCPZ 0
Not Answered

Hi, I have been using the RGB video decoder IC, P/N ADV7181DWBCPZ, in my design. However, this part is now listed as NRND, so I need to replace it with a new IC that offers the same or equivalent specifications. Could you please suggest an alternative...

Video Products hardware Video Decoders adv7181d

91 4 0
by sinkyo
Video

Latest 9 days ago by Ebin
94 3 0
Not Answered
Regarding ADV7393 Rset Pin Voltage 0
Not Answered

We are using two ADV7393 chips mounted on a single PCB. Operating Conditions: ・The same digital data is input to both chips. ・RSET = 4.12kΩ(1%),RL = 300Ω(1%) ・DAC 1 enabled only Observation: When comparing the NTSC video output levels, Unit A outputs...

Video Products hardware adv7393 Video Encoders

94 3 0
by Kiranmai
Video

Latest 13 days ago by PoornimaSubramani
338 10 0
Not Answered
Output video starts to move and won't lock again. 0
Not Answered

Hi, We are configuring the ADV7403 to receive an RGB signal with four wires. After we configure ADC, the expected output video is proper, but all of a sudden it starts to move and won't lock again. What could be the problem? Upon examining it with...

Video Products software Video Decoders adv7403

338 10 0
by SHIGETO
Video

Latest 14 days ago by PoornimaSubramani
185 3 0
Not Answered
When externally generated I2S is input to the ADV7511, the CTS value becomes incorrect. 0
Not Answered

We are generating the I2S signals externally and inputting them to the ADV7511, and we would like to fix the sampling frequency at 48 kHz. When the HDMI source’s sampling frequency is 48 kHz, everything works correctly. However, when the HDMI source’s...

hardware adv7511 HDMI/DVI Transmitters HDMI/DVI Devices

185 3 0
by kaihatsuk
Video

Latest 15 days ago by PoornimaSubramani
387 12 0
Not Answered
How to change the sampling rate on the ADV7626 0
Not Answered

Audio is set to I2S mode. To ensure that audio always outputs at 44.1 kHz, even when the input device is set to a frequency other than 44.1 kHz, the ADV7626's Tx settings for N and CTS are set to 48 kHz. However, when the input device is set to a...

Datasheet/Specs HDMI/DVI Transmitters samplingrate adv7626 HDMI/DVI Devices audio Show More

387 12 0
by ThomasQ
Video

Latest 17 days ago by PoornimaSubramani
79 1 0
Not Answered
MAX7219/7221 driving series LEDs (high voltage segments) 0
Not Answered

I'm curious about the application circuit shown in figure 2 of the MAX7219 datasheet to drive display units that have a high forward voltage (typically 3-5 LEDs in series for each segment). The circuit leverages +5V and -5V power supply rails, so that...

Video Products MAX7219 Dual-Supply Analog Switches and Multiplexers Datasheet/Specs hardware application note MAX7219 - IC Display Driver Electronics Analog Switches Multiplexers switches and multiplexers adg333a Show More

79 1 0

Popular Forums

Product Forums

Application Forums

Design Center Forums

Highlighted Webinar

Places

Libraries

Latest Webinars

Challenge Yourself!

What's Brewing

Places

Resources

Highlighted Blogs

Latest Blogs

ADI Blogs

Visit ContentZone

Featured Content

View Content By Industry

View Content By Technology

Q&A

Not Answered
Faulty DDC communication between ADV7619 as receiver and PC 0
Not Answered

Not Answered
ADV7181C Register Settings for STANAG3350 Signals 0
Not Answered

Not Answered
The image is not centered and doesn't fill the screen. 0
Not Answered

Not Answered
Analog CVBS PAL to MIPI CSI 2 AND MIPI DSI 2 to Analog PAL conversion Chip 0
Not Answered

Not Answered
Query on Black bands seen with ADV7281 0
Not Answered

Not Answered
advice on low-latency composite video to HDMI/DP chain (ADV7280 + transmitter) 0
Not Answered

Not Answered
Entering in free run mode when I switch between 2 video souces 0
Not Answered

Not Answered
Evaluation board BoM 0
Not Answered

Not Answered
Luma dynamic range sometimes shrinks 0
Not Answered

Not Answered
ADV7181DWBCPZ 0
Not Answered

Not Answered
Regarding ADV7393 Rset Pin Voltage 0
Not Answered

Not Answered
Output video starts to move and won't lock again. 0
Not Answered

Not Answered
When externally generated I2S is input to the ADV7511, the CTS value becomes incorrect. 0
Not Answered

Not Answered
How to change the sampling rate on the ADV7626 0
Not Answered

Not Answered
MAX7219/7221 driving series LEDs (high voltage segments) 0
Not Answered

Q&A

Not Answered Faulty DDC communication between ADV7619 as receiver and PC 0 Not Answered

Not Answered ADV7181C Register Settings for STANAG3350 Signals 0 Not Answered

Not Answered The image is not centered and doesn't fill the screen. 0 Not Answered

Not Answered Analog CVBS PAL to MIPI CSI 2 AND MIPI DSI 2 to Analog PAL conversion Chip 0 Not Answered

Not Answered Query on Black bands seen with ADV7281 0 Not Answered

Not Answered advice on low-latency composite video to HDMI/DP chain (ADV7280 + transmitter) 0 Not Answered

Not Answered Entering in free run mode when I switch between 2 video souces 0 Not Answered

Not Answered Evaluation board BoM 0 Not Answered

Not Answered Luma dynamic range sometimes shrinks 0 Not Answered

Not Answered ADV7181DWBCPZ 0 Not Answered

Not Answered Regarding ADV7393 Rset Pin Voltage 0 Not Answered

Not Answered Output video starts to move and won't lock again. 0 Not Answered

Not Answered When externally generated I2S is input to the ADV7511, the CTS value becomes incorrect. 0 Not Answered

Not Answered How to change the sampling rate on the ADV7626 0 Not Answered

Not Answered MAX7219/7221 driving series LEDs (high voltage segments) 0 Not Answered

Not Answered
Faulty DDC communication between ADV7619 as receiver and PC 0
Not Answered

Not Answered
ADV7181C Register Settings for STANAG3350 Signals 0
Not Answered

Not Answered
The image is not centered and doesn't fill the screen. 0
Not Answered

Not Answered
Analog CVBS PAL to MIPI CSI 2 AND MIPI DSI 2 to Analog PAL conversion Chip 0
Not Answered

Not Answered
Query on Black bands seen with ADV7281 0
Not Answered

Not Answered
advice on low-latency composite video to HDMI/DP chain (ADV7280 + transmitter) 0
Not Answered

Not Answered
Entering in free run mode when I switch between 2 video souces 0
Not Answered

Not Answered
Evaluation board BoM 0
Not Answered

Not Answered
Luma dynamic range sometimes shrinks 0
Not Answered

Not Answered
ADV7181DWBCPZ 0
Not Answered

Not Answered
Regarding ADV7393 Rset Pin Voltage 0
Not Answered

Not Answered
Output video starts to move and won't lock again. 0
Not Answered

Not Answered
When externally generated I2S is input to the ADV7511, the CTS value becomes incorrect. 0
Not Answered

Not Answered
How to change the sampling rate on the ADV7626 0
Not Answered

Not Answered
MAX7219/7221 driving series LEDs (high voltage segments) 0
Not Answered