Is there a similar SDR, like the ADALM-PLUTO but AD9364 based, not AD9363 as ADALM-PLUTO SDR? The AD9363 325 to 3800Mhz coverage is insufficient for some applications. The AD9364 coverage 70 to 6000 Mhz is much better in this sense.
You can extend the range of Pluto to these specifications with a small software change: Customizing the Pluto configuration [Analog Devices Wiki]
This will actually happen by default during the install process of MathWorks' Hardware Support Package: ADALM-PLUTO Radio Support from Communications System Toolbox - MATLAB & Simulink
I purchase a plutosdr today and when I trying to increase the bandwidth using step-1 (Updating to the AD9364).
After all the steps are successfully executed as mentioned above I am trying to set the RX LO frequency of 100 MHz in IIO Oscilloscope. But it does not allow me to do so and it goes to frequency of 500 MHz (which was set earlier).
When I logged in to Pluto it is showing v0.30.
For my application I have to work on lower frequencies.
Can you provide the output of "iio_attr -a -C" from the command line after rebooting the radio?
Also, I will note that Pluto is not guaranteed to work outside datasheet specifications. If you absolutely have to work below 325 MHz buy a board with a AD9364 or AD9361.