Is it possible to capture signal through receiver of AD-FMCOMMS5 board using linux (in AD IIO Oscilloscope) installed in memory card , connected in ZC-706
After the phase calibration finished you should only see the received signals.
However during phase calibration - some TX are internally routed to the RX channels, to measure and compensate the phase offsets.
So this leads me to think your setup still has some loopbacks enabled.
Yes its possible by saving the file using save option in IIO scope.
For more details refer WiKi
IIO Oscilloscope [Analog Devices Wiki]
moved to Linux sub space for more inputs
Thanks for reply. if i transmit 4 signal using all 4 transmitter and i want to receive all 4 signals. then which voltage i would select.
because i noticed that when i transmit signal through TX1 and received it through RX4 then on Voltage 0 , voltage 1 its shows transmitted signal and on voltage 6,voltage 7 it shows received signal. So i got confused that these voltages (voltage0 to voltage 7) showing transmitted or received signals.
Retrieving data ...