Based on which parameter can I set the values for dc_offset_attenuation_high_range and low_range, dc_offset_count _high_range and low_range?
Below API perform RF DC offset calibration
/** * Perform a RF DC offset calibration. * @param phy The AD9361 state structure. * @param ref_clk_hz The RX LO frequency [Hz]. * @return 0 in case of success, negative error code otherwise. */static int32_t ad9361_rf_dc_offset_calib(struct ad9361_rf_phy *phy, uint64_t rx_freq)
RF DC offset calibration compensates for the DC offset in the RF path. (internal to the chip).
ADI provided Drivers/API will take care of calibrations and you may not need to modify same for most cases.
For details on different parameters, Please refer UG-671.
Is the API int32_t ad9361_do_calib is what you mentioned above?
Thanks for the reply. Can you share with me the link which contains the lists of the available API's?
Retrieving data ...