AnsweredAssumed Answered

AD5781 hardware and software setup

Question asked by Peter109 on Aug 27, 2017
Latest reply on Aug 29, 2017 by isantos

Dear Friends:

I plan to use AD5781 for my project. I have three questions: 1) if I plan to set the LDAC permanently low, should I use a resistor between LDAC and GND? 2) if I do not plan to use CLR, can this pin be disconnected? 3) if I want the a predetermined Vout right after the chip goes to normal mode, I should load DAC register before the control register, am I right?

Thank you

Outcomes