Why are jumpers JP1 and JP2 not installed on the AD9739A-FMC-EBZ Rev C evaluation board I purchased. It seems like there is no power to the board without these jumpers.
Thank you for your help!
This may help. It seems it is a mistake, I have asked the concerned parties to look at it.
Setting up the ad9739a_fmc_ebz
Thank you for pointing out, someone more familiar with the process will look at this, confirm, correct and reply.
A lot of us are on summer holidays, so please be patient.
I have noticed on the Rev A board J17 was used for external power to the AD9739A-FMC-EBZ. Then on the Rev B board J17 was deleted and the power comes in through the FMC connector. It looks like Rev C is also only powered via the FMC connector. However, Rev A, Rev B, and Rev C all have jumpers labelled JP1, JP2, etc but these are not called out on the Bill of Materials. Is there some other option for powering the Rev C board other than the FMC connector? If not, are the missing jumpers JP1 and JP2 on my Rev C boards simply a mistake in manufacturing and need to be added for the board to operate? Thank you for your help!
Retrieving data ...