AnsweredAssumed Answered

Zynq SDR Setup Error

Question asked by onishik on Aug 4, 2017
Latest reply on Aug 7, 2017 by travisfcollins

I have bought the AD FMCOMMS3 module for a software defined radio for my ZC706 board and wanted to start running example designs. I installed the xilinxzynqbasedradio.mlpkginstall downloaded from here http://www.mathworks.com/matlabcentral/fileexchange/48491-communications-system-toolbox-support-package-for-xilinx-zynq-based-radio

I then ran the setup by running the commands:

>>dev = sdrdev('ZC706 and FMCOMMS2/3/4')

>>launchSetupWizard(dev)

I followed the instructions here https://www.mathworks.com/help/supportpkg/xilinxzynqbasedradio/ug/guided-host-radio-hardware-setup.html and got an error that looked like this:

 

I have tried looking at the common problems FAQs but none of those seemed to help. I tried to do an info and the results were:

I am unsure of what is wrong at this point if it can read data from the Zynq device but does not get data from the RF card. Is this a problem with my setup or something wrong with the RF card?

 

Any help would be greatly appreciated.

Outcomes