I'm working on board having ADSP21065L...
I found there is no in built driver for UART. Can anybody send mi template code for RS232 loopback??
Sorry about the delay in getting back.
Please the example along with the App note that i mentioned. You may use the same code but only change the setting based no the UART you are using. If you are still finding issues configuring please let me know.
UART module is not present in the ADSP-2106x, so you will need to implement it using SPORTs or flags. Please refer to EE note EE-191, Implementing a Glueless UART Uaing SHARC DSP SPORTs.
Hope this helps
You may also find the information to connect flags to UART, from Software Module Chapter ADSP-21xx Hardware Referece Manual.
I'm using UART IC XR16L788 with SHARC.
Kindly tell me the necessary settings. UART interrupt
is mapped to IRQ0. And other control signals are mapped
accordingle. 8 bit data and address is mapped between ADSP
Retrieving data ...