I purchased two EVBs from Analog to implement a test of with AD9467 ADC.
I’m having some problems related to the SpiController SW.
I am following step by step the procedure described here:
I have problems at the very beginning of the SPIController Setup. When I launch the application, I get the following message:
Read Test Failure. Chip ID is not Known. New DUT() will not proceed. Check Chip Select $ or USB cable. Cfg should be re-loaded.
- Reading CHIP ID(1), I get a wrong part Number.
- Reading GRADE(2) gives “TBD”)
Trying to load the proper cfg file is unsuccessful.
Has anyone been faced to the same kind of problems?