AnsweredAssumed Answered

RX port mapping of the EV-RADAR-MMIC2 with EV-ADAR-D2S

Question asked by pdh1 on Jul 13, 2017
Latest reply on Jul 14, 2017 by pwalsh

Hi,

I was trying to go through the testing of the EV-RADAR-MMIC2 with the step-by-step guide in the user guide (UG-866) in page 13 (Figure 8). The problem is that the mapping of the baseband signals from the output of the ADF5904 to the output of the EV-ADAR-D2S is a mess. 
In table 1 (page 5) of the same user guide, it says that RX2 corresponds to O8. But if you double check that in Figure 28, O8 corresponds to RX4.
Could you please clarify this to me, to make sure that I am looking at the correct output? (The user guide is attached)

Many thanks in advance.
All the best,
Pascual

Attachments

Outcomes