AnsweredAssumed Answered

Question about parameter of FMCOMMS3 in Gnuradio

Question asked by mike.chen on Jun 29, 2017
Latest reply on Jul 3, 2017 by mike.chen

Dear all

                The attenuation of TX1&TX2 didn't work in my block. I've set the value 10dB,  but when I run the transmitter.grc, the block could run normally, but there isn't any attenuation in my transmitter just like the picture as follows. And I want to know the relation of amplitude between transmitter and receiver. For example, while the amplitude of tx_single is30000,and the “gain mode” in receiver is “slow”,Does the max value of rx_signal be limited?Because I could see a constant amplitude in the receiver although I improve the amplitude of tx_signal exceed 30000.

          Thank you very much!

Mike_chen

Outcomes