AnsweredAssumed Answered

AD654 erroneous pulse output

Question asked by ricky on Jun 13, 2017
Latest reply on Aug 24, 2017 by jcolao

Hi All,

 

One of my customer has trouble with AD654 V/F Converter in his renewal design.

The current design circuit is shown in attached document.

As shown in the attached sheet, the output terminal of AD654 (FOUT) is connected to photo-coupler input and is pulled up to +15 supply through 1.5kohm and LED in the photo-coupler.

In this configuration, the problem is the current at FOUT terminal at logic 1 state.

The output voltage scope shot is also attached the same sheet.

As shown in the scope shot, FOUT waveform is not stable at logic 1 state thus the pin5 of photo-coupler shows erroneous pulse output.

Could you advise us what is cause this problem?

 

Best Regards,

Ricky

Outcomes