My customer is testing HMC7992 in 4Ch. RFID Reader.
2 Channels(ANT2, ANT3) work well. But the other 2 Channel shows 0.5dB less output power and half of sensitivity.
When I try to connect SMA connector witin same pattern length, I cannot find any difference among each channel.
Is there any root cause for this issue or any missing for PCB design?
One more question is
My customer is using RF5110G(RFMD) as a RF Power amp in this project.
And she faced themal issues on it when she drive RF AMP continuously.
Could you recommend the substitute of RF5110G?
How about HMC453? I will be appreciated if you recommend more cost effective RF AMP for RFID(920MHz)...