AnsweredAssumed Answered

AD9680 Signal Monitor

Question asked by rainerb on May 30, 2017
Latest reply on May 30, 2017 by UmeshJ

Hello,

 

I am using the AD9680 on a DAQ2 board and want to use the signal monitor. The block diagram in the datasheets shows that the monitor is connected to both channels (A and B). But I found no possibility to switch between these two channels. It seems to me, that only channel A can be monitored. Is there any (undocumented) bit in the register bank, to switch between the two channels?

 

Regards Rainer

Outcomes