I want to use ADF4351 to output 102.4MHz, And I want to use balun,how to choose the balun? Can recommand a model?
There are LC balun values provided on the data sheet page 27. These will probably work fine, even if the lowest stated frequency was 137 MHz.
What is the low frequency cutoff frequency? What are you trying to do by using a balun? The part already has a differential output.
Assuming you're converting from the ADF4351 differential output single-end via a balun, what is the bandwidth of the frequencies you wish to pass through the balun? Until we know this, we cannot provide a recommendation.
I'm so sorry ,The frequency is 100MHz to 250MHz,Thanks!
主题：Re: - Re: ADF4351 use balun
Re: ADF4351 use balun
reply from jdobler in RF and Microwave - View the full discussion
Reply to this message by replying to this email, or go to the message on EngineerZone
Start a new discussion in RF and Microwave by email or at EngineerZone
Following Re: ADF4351 use balun in these streams: Inbox
This email was sent by EngineerZone because you are a registered user.
You may unsubscribe instantly from EngineerZone, or adjust email frequency in your email preferences
Retrieving data ...