AnsweredAssumed Answered

Ad9956 External control

Question asked by robmwj on Apr 7, 2017
Latest reply on Apr 9, 2017 by mcee

Hello, I am currently hoping to run my Ad9956 using an external FPGA program. When I looked at the provided manual (linked below) I see it tells me to:

 

Set W3 to parallel, set W4 to manual,

and remove W15 (or leave it stored as a shunt).

 

However, on the board it says "USB ID enable, do not remove" next to the W15 jumper. Im a bit confused as to what I should do with this jumper. Any help would be greatly appreciated.

 

http://www.analog.com/media/en/technical-documentation/evaluation-documentation/37266156101257AD9956_PCB_0.pdf 

Outcomes