I have been reading through the documentation and I cannot figure out how to get the device to operate without invoking a debug session with CCES. To clarify, I want the board to run by powering it with a portable 5V DC supply. I switched the jumper to tell the board to pull power from the micro USB port, and the green LED comes on when I supply it power, but it does not run the code that I have loaded onto the board. I can't figure out exactly what I need to do to get the device to operate in standalone mode. I ran the question by 3 different ECE faculty members and all of them suggested I simply post here. If you have any insight on the matter, it would be greatly appreciated.
- Josh L