I am creating my own board with the ADSP-21489 with 176 Pins.
I have the EZ Kit with Stand Alone Debug Agent.
On the board are two connectors JTAG P1 and ZP1. For the P1 I know the connections to the DSP from the schematic. But the ZP1 is not included in the schematic. How are the pins of ZP1 connected to the DSP?
I measured the following:
1 5 V supply
2 5 V supply
3 NC (?)
4 3.3 V supply
5 NC (?)
7 NC (?)
8 DA Soft Reset
9 -14 GND
Is this correct?
In the EE-68 document Pin 1 is connected to GND but on the EZ Kit its 5V.
So I also have to route Pin 1 to 5V?